Table des Matières
Publicité
20. Turn the aerator right side up and assemble the front
ends of the hitch arms together using two 5/16" x 1-1/4"
hex bolts (C) and 5/16" nylock nuts (G). Do not tighten
yet. See figure 13.
21. Assemble the two hitch brackets to the top and bottom
of the hitch arms using two 5/16" x 2" hex bolts (B) and
5/16" nylock nuts (G). Do not tighten yet. See figure
13.
22. Assemble the 3/8" hitch pin (J) through the hitch brackets
and secure it with a 1/8" hair cotter pin (I). See figure
13.
(C) 5/16" x 1-1/4"
HEX BOLT
(G) 5/16" NYLOCK NUT
FIGURE 13
23. Tighten the bolts and nuts assembled in step 20. Tighten
the bolts and nuts assembled in step 21.
Tighten the bolts and nuts assembled in step 18. Tighten
the bolts and nuts assembled in step 3. Tighten the
bolts and nuts assembled in step 17.
24. Assemble a hitch arm mount bracket to the axle bracket
using two 5/16" x 1" carriage bolts (E) and 5/16" nylock
nuts (G). Do not tighten yet. See figure 14.
(E) 5/16" x 1"
CARRIAGE BOLT
FIGURE 14
(B) 5/16" x 2"
HEX BOLT
(J) 3/8" HITCH PIN
(G) 5/16"
NYLOCK NUT
(I) 1/8" HAIR
COTTER PIN
FRONT VIEW
(G) 5/16" NYLOCK NUT
REAR VIEW
ENGLISH
25. Assemble the lift handle through the tray and attach it
to the hitch arm mount bracket assembled to the axle
bracket. Use a 5/16" x 1" hex bolt (D) and a 5/16" nylock
nut (G). Tighten. See figure 15.
26. Position the hitch arm mount bracket so that there is
side tension on the lift handle when it is locked in the
up position. Tighten the nuts. See figure 15.
27. Assemble the grip (T) onto the end of the lift handle.
See figure 15.
FIGURE 15
8
(T) GRIP
LIFT HANDLE
(G) 5/16" NYLOCK NUT
(D) 5/16" x 1"
HEX BOLT
REAR VIEW
Publicité
Table des Matières
