VelLight LEDA320NW Mode D'emploi page 4

This device is not suitable for dimming.

Familiarise yourself with the functions of the device before actually using it.

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.

Use the original packaging if the device is to be transported.

Keep this manual for future reference.
4. Features

high-power high-bay LED

100 W LED COB module

LED driver: high-quality constant current LED driver
Mean Well: HLG-120H-36A
o

housing: aluminium

optional reflectors (not included): LEDA320/60A, LEDA320/120A, LEDA320/60C
5. Installation
Refer to the illustrations on page 2 of this manual.
1. Screw the hook fully into the hook housing. Tighten the hook with the lock screw.
2. Slightly unscrew the four screws.
3. Place the lamp onto the reflector so that the screws fit into the holes on the reflector.
4. Rotate the reflector so that the screws slide into the slots.
5. Tighten the screws to fix the reflector to the lamp.
It is the responsibility of the installer to ensure that appropriate hardware is used to fix
the luminaire.
6. Mounting

Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The construction to which the device is attached should be able to support 10 times the weight of the
device for one hour without deformation.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

Have a qualified electrician carry out the electric connection.

The installation has to be approved by an expert before the device is taken into service.
V. 01 – 12/05/2015
LEDA320NW
4 ©Velleman nv