Intended Use; Assembly And Adjustments - DeWalt DWPW2400 Guide D'utilisation

English
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
OPM .................... oscillations per
minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.

Intended Use

This pressure washer is intended for cleaning boats, cars,
decks, driveways, grills, house siding, motorcycles, patios,
and outdoor furniture.
DO nOT use under wet conditions or in presence of flammable
liquids or gases.
DO nOT let children come into contact with the tool. Supervision
is required when inexperienced operators use this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
4
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... avoid staring at
light
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
IPXX .................... IP symbol
Specifications
Maximum Pounds per Square Inch
Rated Gallons per Minute*
Electrical Requirements
Electrical Cord
High Pressure Hose
Minimum Amp Source
Pressure of Inlet Water*
Inlet Water
Soap Consumption Rate
*Water flow and maximum pressure ratings determined in accordance with CETA CPC-100.
Assemble Frame Handle (Fig. A–C)
Your pressure washer is not fully assembled in the carton.
1. To assemble the frame handle
unit 7 , line the upper poles
16 so the detent pins snap into position.
Fig. B
Fig. C
7
High Pressure Hose Storage (Fig. D)
1. To store the high pressure hose
and secure it with the attached strap as shown in Fig. D.
Fig. D
2,400
1.1
120V ~60Hz, 13A
AC
35 ft. (10.6 m)
25 ft. (7.6 m)
15A
20-100 PSI
Cold Tap
10% MAX
9 to the pressure washer
15 with the lower poles
15
16
9
1 neatly coil the hose
1