Front Wheel - Youin Amsterdam Manuel De L'utilisateur

Operation Instruction
Adjust the high limit screw so that the
guide pulley and the smallest sprocket
are lined up vertically. Re-tighten the
cable, pull out any slack, and re-tighten
the anchor bolt securely. Shifting through
the gears, making sure that each gear is
achieved quietly and without hesitation. If
necessary, use the barrel adjuster to fine
tune the cable tension by turning it the
direction you want the chain to go. For
example, turning clockwise will loose the
cable tension and move the chain away
from the wheel, while turning counter-
clockwise will tighten cable tension and
direct the chain to the wheel.

Front Wheel

Installation
1. Make sure the brakes are loose enough to allow the wheel to pass through the
brake pads easily.
2. Place wheel into fork dropouts.
3. Install retaining washers with r aised lip pointing towards the fork, and insert into
the small hole of the fork blade.
NOTE: Some bikes may have step retaining washers in place of the retaining washer.
If so install the step retaining washer, raised portion sliding into the fork dropouts.
4. Install axle nuts and tighten. Make sure the wheel is centered between the fork
blades.
5. Spin the wheel to make sure that it is centered and clears the brake shoes. Tighten
the brakes if necessary.
High gear
adjustment screw
Low gear
adjustment
screw
Barrel
Adjuster
Rear Derailleur
Side View
Nipple
Ferrule
Lock
nut
Barrel
Adjuster
Handlebar
ENGLISH 15