Battery Capacity - Sunrise Medical Empulse F55 Notice D'utilisation

6.7.1 Lights:
The lights can be switched on or off by pressing the "+"
button for 2 seconds. This is displayed by the relevant
symbol on the display (upper left corner).

6.7.2 Battery capacity:

This is displayed in 20% steps. As soon as the battery
display starts to flash, the battery must be charged
immediately.
6.7.3 Display mode:
By pressing the "On/Off" button you can now select
different display modes:
1. Display mode: "ODO" - Main
display: Speed
2. Display mode: "TRIP" - Main
display: Speed
3. Display mode: "TIME" - Speed
4. Display mode: "TRIP MAX" -
Main display: max. speed driven
5. Display mode: "TRIP AVG" –
Main display: average Speed
6. Display mode: "Instantaneous
power"- Main display: Speed
DANGER!
• Only carry out setting work when the device is
stationary and never when driving.
Empulse F55 Rev.D
6.7.4 fault code display:
when the electronics detect faults in the system, these
are displayed in the form of fault codes on the display.
Faults can arise once sporadically. Each time the device
is restarted, the fault code is deleted. If the fault should
arise again, we recommend that you make a note of the
fault code and contact your dealer.
6.7.5
You can open the settings menu in order to carry out
basic settings.
NOTE:
• These settings can only be carried out when stationary.
Additional
display: Total km
1. Deleting the odometer:
press the "+" and "-" buttons at the same time and keep
Additional
them pressed for 2 seconds. The "tC" menu opens.
display: Daily km
Additional
display: Travel
time
Additional
display: Daily km
"On/Off" button for 2 seconds in order to confirm the entry
and leave the menu.
Additional
display: Daily km
or
Press the "On/Off" button briefly to confirm and toggle to
Additional
the next menu point.
display: Power in
Watt
The fault code always starts
with the letters "Err" and ends
with a two-digit number:
Fault code
21 Current Abnormality
22 Throttle Abnormality
23 Motor Abnormality
24 Motor Hall Signal Abnormality
25 Brake Abnormality
30 Communication Abnormality
Settings:
The display shows "tC-n",
pressing the "+" button you
can toggle between "tC-n"
(do not zero daily
kilometres) and "tC-y"
(zero daily kilometres).
Select "tC-y" to zero the
odometer and press the
Definition
21