Wood's SW22FW Guide D'instructions page 7

PROBLEM SOLUTION
Dehumidifier does not start - Check that dehumidifier is connected to electricity and that fuse has not gone
- If the warning light is on, check that the water reservoir is empty and correctly placed in the dehumidifier.
Check that float is free
- Check that hygrostat is working. Dehumidifier should start when hygrostat is in Maximum position
Does not dehumidify - Check that fan is spinning
- Check that air can flow freely through the dehumidifier. Front grid and air filter should be clean and dehumidifier should stand
20-30cm from wall
- Listen for sound of compression, but bear in mind that the dehumidifier may be in a dehumidifying cycle, when the compression stops. Wait initially for about 35
minutes.
- Check that a thick coating of ice has not formed on the cooling coils.
High noise level - Increase distance between dehumidifier and surrounding surfaces
- Cooling coils may be in contact with one another and cause vibration. Disconnect dehumidifier from electricity and separate coils
Ice formation on cooling coils - Remove air filter at rear of dehumidifier and check that no dust or fluff is obstructing passage of air through machine
No water enters reservoir - Check for obstruction to drip-tray above water reservoir
Does not turn off when water - It is important that the float moves freely in the water reservoir. If it does not, it will not respond to water levels and prevent dehumidifier from stopping
reservoir is full
The Led is flashing in green - To low temperature- increase room temperature.
If none of the above works, you should contact your nearest retailer for checking and possible overhaul of dehumidifier
Operating Instructions
GB
7