Installation Clearances - Maytag MHWE200XW Guide D'utilisation Et D'entretien

Installation clearances

■ The location must be large enough to allow the washer door
to be fully opened.
■ Additional spacing should be considered for ease of installation
and servicing. The door opens more than 90°, and it is not
reversible.
■ Additional clearances might be required for wall, door, and floor
moldings.
■ Additional spacing of 1" (25 mm) on all sides of the washer
is recommended to reduce noise transfer.
■ Companion appliance spacing should also be considered.
Washer Dimensions
1
50 / "
4
(1276 mm)
Recommended installation spacing for custom undercounter
installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
2" (50 mm)
36" min.
(914 mm)
1"
(25 mm)
27"
(686 mm)
36"
(914 mm)
30 1 / "
2
(775 mm)
27"
1"
(686 mm)
(25 mm)
Recommended installation spacing for recessed or closet installation,
with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
48"
(1220 mm)
1" 30 1 / " 4"
2
(25 mm) (775 mm) (102 mm)
A
A. Side view - closet or confined area
B. Closet door with vents
Recessed or closet installation - Washer on pedestal
1"
27"
(25 mm) (25 mm)
(686 mm)
A
A. Recessed area
B. Side view - closet or confined area
(76 mm)
48 in. 2
(310 cm 2 )
24 in. 2
(155 cm 2 )
(76 mm)
B
38" min.
(965 mm)
1" 1" 30 1 / " 4"
2
(25 mm) (775 mm) (102 mm)
B
3"
3"
5