GB
The EC declaration of conformity for this appliance is available in the Products section of our
website www.ceado.com.
INSTALLATION
Comply with the safety recommendations indicated above and hereafter when installing the
appliance.
1.
Make sure that the mains voltage is as indicated on the rating label of the appliance and that
the electrical system is grounded and equipped with a switch.
2.
Install the appliance in a DRY, PROTECTED place, far from water sprays or splashes, heat
sources, open flames and inflammable substances.
Place the appliance on a flat, horizontal, stable surface where it cannot tip over.
3.
Make sure the switch on the appliance is in the "OFF" position and plug it into a socket
protected by a suitably rated circuit breaker (MCB) or fuses.
Do not use an adaptor plug.
4.
Stretch the power cable out to full length. Do not let it pass over sharp edges or hot surfaces.
Do not let oil spill on it. Do not let the power cable hang loose from the counter on which the
appliance stands.
USE
Before first use: rinse all of the parts that will have contact with food in running water i.e.:
spout, juice container, reamers, strainers, splash retainer, splash cover, cones (see Fig. 1 and
Fig. 2).
Preparing the Juicer
Before using the juicer for the first time, refer to the "Cleaning and maintenance" section to
clean all parts. Then complete the following steps to prepare the juicer each time you use it:
NOTE: Each time you use the juicer, check to be sure that there are no cracks in the cone,
reamer, or strainer.
1
Place the container onto the base.
2
Check to see that the strainer and spout are not plugged with pulp or seeds from the last use.
Then place the container onto the base.
3
Insert the reamer-strainer into the container over the motor shaft.
Automatic model SL98
4
Place the stainless steel reamer into the container and over the motor shaft. Ensure that the
reamer is seated all the way down on the shaft.
5
Make sure the cone and splash cover are attached tightly to the handle.
17