Important Instructions; Instructions For Use - Princess FOOT SPA DELUXE Mode D'emploi

PRINCESS FOOT SPA DELUXE
Read the instructions carefully before you use the FOOT SPA for the first time and retain for later reference.
Check whether the mains voltage in your home corresponds to that of the appliance.
The FOOT SPA is the perfect way to soothe tired and painful feet, which helps to relax the entire body.
The FOOT SPA can be used to massage your feet and it can provide massaging heat. Using the infrared
function you can warm your feet and stimulate the blood circulation.
SETTINGS
Setting 0 - Off
Setting 1 - Vibration
Setting 2 – Infrared & Keep warm function
Setting 3 – Vibration & Infrared & Keep warm function

IMPORTANT INSTRUCTIONS

- Remove the plug from the socket when the bath is being filled, emptied or cleaned.
- Do not stand in the bath.
- You can use a little bit of bath oil in the bath. Do not use any other products in the water. Use only
clean tap water.
- If you have diabetes, first consult your doctor before using the bath.
- If you have any wounds or other health problems with your feet or legs, or if you experience pain,
itching or a burning feeling after using this bath, consult your doctor first before using the bath again.
- Do not fill the bath higher than the top marker line inside the bath.
- Place the bath on a stable, level floor, but not on thick carpeting or a thick rug, as this could block the vents.

INSTRUCTIONS FOR USE

- Use a jug, small bucket or something similar to fill the bath with warm or cold water, whichever you
prefer. The bath heater is strong enough to maintain the temperature of warm water for a period of
time, but not to warm up cold water. So if you want a warm foot bath, use warm water of the desired
temperature.
- Place a chair in front of the bath, plug in the appliance and switch it to the desired setting.
- First sit and then place your feet in the bath. Do not stand in the bath!
- Make sure that the water does not splash over the edge of the bath or on the selector switch.
- After use, switch off the bath and remove the plug from the socket.
- Clean the bath with clean water and a mild detergent, then dry off. Do not use any abrasive detergents
or sponges.
SAFETY
- Do not wind the cord tightly around the bath.
- Do not use the foot bath in the bathroom or shower, or near a sink(s) filled with water.
- Operate the bath with dry hands.
- Only allow the bath to be used by persons who can read and understand these instructions.
- Do not use the bath if it is damaged or if the cord is damaged. In this case, return the bath for repairs.
A damaged cord can only be replaced by our technical service department with the special tools.
- This foot bath is intended for household use only.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by persons (including children) with a physical, sensory, mental or motorial
disability, or lack of experience and knowledge can cause hazards. Persons responsible for their safety
should give explicit instructions and supervise the use of the appliance.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
As the colours of the wire in the mains lead of this appliance may not correspond with the
colour markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with
the letter N or coloured black.
ART. 565780
4