Electrical Connection - Proficook PC-TYG 1143 Mode D'emploi

• Children shall not play with the appliance
• Cleaning and user maintenance shall not be made by children un-
less they are older 8 years and supervised.
• Keep the appliance and its cord out of reach of children less than
8 years.
Description of parts
1 Bamboo frame
2 Grease trough
3 Fat collecting tray
4 Griddle (featuring grooves and flat plate)
5 Thermostat socket
6 Pilot lamp
7 Temperature control
8 Temperature sensor – measures the tempera-
ture of the plate
9 Mains lead
10 Mains plug

Electrical Connection

Power Requirements
The appliance can consume a total of 2200 W.
With this connected load a separate supply line
protected by a 16 A household circuit breaker is
recommended.
CAUTION: Overload!
• If you use extension leads, these should have
a cable cross-section of at least 1.5 mm².
• Do not use any multiple sockets, as this appli-
ance is too powerful.
Connection
• Make sure that the appliance is switched off.
The temperature control (7) must be set to
"OFF".
• Make sure that the device voltage (see "name
plate") and the line voltage match.
• The mains plug (10) should only be inserted
into a correctly installed socket with earthing
contact.
38
Before initial use
1. Take the appliance out of its packaging.
2. Remove all packaging materials, such as foils,
filling materials, cable ties and cartons.
3. Check that all accessories are included in the
box.
4. Operate the appliance on the highest setting
for 10 minutes.
5. Turn the appliance off and disconnect the
power plug.
NOTE:
• This process normally produces a little smoke
and some smells. Provide sufficient ventila-
tion.
• Clean manufacturing residues and dust from
the device as described under "Cleaning".
Operation
1. Place the appliance on a level, water and heat-
resistant surface. The surface should be easy
to clean as spattering is unavoidable. If resting
on a sensitive surface, place a heat-resistant
plate beneath it.
2. Place the griddle (4) on the bamboo frame (1)
by sticking the power socket through its gap.
Place its feet in the respective holes of the
frame. Check if the griddle (4) stands on the
frame solidly.
3. Place the fat collecting tray (3) below the
grease trough (2).
4. Please ensure that the temperature control
(7) is turned to "OFF" (off) and insert it into the
socket of the thermostat (5).