Melitta Caffeo SOLO Mode D'emploi page 24

Fault
Coffee only flows drop-by-
drop.
Coffee does not flow.
The grinder is not grinding.
Loud grinder noise
Bean symbols
flashing although the bean
container is full.
illuminates on the display.
The cleaning or descaling
process was interrupted.
The brewing unit can no
longer be reinserted after
removal.
The symbols for cleaning
and stand-by
alternately.
Continuous flashing of all
buttons
24
BA_Solo_082016.indd 24
Troubleshooting
Cause
Grinding fineness is too fine.
Water tank not filled or
incorrectly inserted.
The brewing unit is clogged.
The beans are not falling into
the grinder.
Foreign objects in the grinder.
Foreign objects in the grinder.
are
Insufficient quantity of ground
beans in the brewing chamber
There is air in the lines inside
the appliance.
The power supply was
interrupted, e.g. due to a power
outage.
The brewing unit is not properly
locked.
The actuator is not in the
proper position.
The brewing unit is missing or
not properly inserted.
flash
The brewing chamber is
overfilled.
System error
Solution
Adjust the grinding fineness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Fill the water reservoir and make sure
it is properly inserted.
Clean the brewing unit.
Tap lightly on the bean container.
Call the hotline.
Call the hotline.
Press the buttons for single-cup
dispensing or two-cup dispensing
.
If necessary, fill the water reservoir
and press the button for coffee
strength . The appliance will be
vented.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
Check whether the handle for locking
the brewing unit is correctly engaged.
Switch the appliance off and then on
again. Press the button for single-
and two-cup dispensing
simultaneously for longer than
2 seconds. The actuator is put into
position. Then reinsert the brewing
unit and make sure it is correctly
locked into place.
Insert the brewing unit properly.
Switch off the appliance and switch
it on again using the ON/OFF button
(repeat if necessary) until standby
mode is displayed
Switch off the appliance and switch it
on again via the ON/OFF button
; if this does not solve the problem
send the appliance to the service
department.
and
21.09.2016 07:23:53