Important - Oase Lighted Waterfall Spillway Notice D'emploi

- English -
Installation
WARNING
Risk of electric shock. To reduce the risk of electric shock, be certain that it is connected only to a properly grounded,
grounding-type receptacle.

Important:

● The instructions that follow will show a pond installation and a block wall. Your lighted waterfall can be used in a
variety of applications.
Assembling the Lighted Spillway
1. For maximum water flow, it is recommended that the
largest tubing size for your pump is used.
○ If needed, cut the adapter as shown using a hacksaw;
consult packaging for tubing size.
● The spillway has two outlets to install the adapter. Place
the cap and gasket on the outlet not being used.
2. Attach the adapter to the spillway first, then slip the hose
clamp onto the tubing but do not tighten it. Connect
tubing to the adapter.
NOTE: Tubing is NOT INCLUDED.
3. Tighten the hose clamp using a flathead screwdriver.
For installation in a pond
● After completing "Assembling the Lighted Spillway"
1. Select a level location to place the waterfall spillway.
○ Begin by building a base with the desired waterfall
height.
2. Place the spillway onto the base.
NOTE: It is very important that the spillway is level, so
be sure to check that the structure is level from front to
back as well as left to right.
3. Connect the other end of the tubing to the pump. Place
the pump in the pond.
NOTE: Tubing and pump are not included.
4. Continue building the rest of the structure. Carefully
cover the waterfall spillway and tubing with natural
material for a professional look.
NOTE: Design the structure to fit the tubing through the
back without any kinks.
GFCI
1.
2.
Adapter
hose clamp
Tubing
3.
1.
3.
4.
GFCI
or
2.
4