AEG LK 5689 Mode D'emploi page 35

SWING Oscillation
The inner ventilation grid swivels automatically when you
select the SWING function. The outer ventilation grids can
be adjusted horizontally by hand.
SPEED Speed level
Press the SPEED button to select one of the three different
speeds.
• LOW low
• MEDIUM medium
• HIGH high
TIMER Timer
If you want the timer to switch the device off, press the
TIMER button.
NOTE:
Each time you press the TIMER button, the operating
period is increased. The respective indicator lights indicate
the operating time.
MODE Wind Change Functions
The device has the two special functions: NATURAL and
SLEEP. The speed of the fan buries between the functions.
Press the MODE button to switch these functions on.
• Press 1 x = NATURAL
This mode simulates natural wind movement. Pressing
the SPEED button you can change the speed level.
• Press 2 x = SLEEP
Relax in this mode with rich wind variants. Pressing the
SPEED button you can change the speed level.
• Press 3 x = Normal Mode
Choose the speed level by pressing the SPEED button.
HUMIDIFIER Humidifier
In addition to the fan, you can switch on the air cooler / hu-
midifier. To do so, press the HUMIDIFIER button. The indica-
tor light above this button lights up. This function is suitable
for rooms up to 20 m².
Adding a pleasant level of humidity provides the following
benefits:
• It ensures a healthy room climate and thus your well-
being.
• It prevents the raising of dust and is therefore ideally
suited for allergy sufferers.
• Your skin is supplied with moisture.
• It protects your furniture from drying out and prevents
a forming of gaps in parquet or wood floors.
• Electrostatic charge in the air is suppressed.
Refill Water
1. Switch off the appliance.
2. Disconnect the plug from the mains.
3. Proceed as described under "Fill with water".
LK5689_IM
Change the Water
The water should be changed every 3 - 4 days.
1. Switch off the appliance.
2. Disconnect the plug from the mains.
3. Remove the air intake filter.
4. Loosen the screw on top of the humidifier cartridge.
5. Drag the humidifier cartridge forward and then upward
with the handle.
6. Remove the water tank.
7. Empty the water tank and rinse it with clean water.
8. Proceed as described under 4 - 6, in the section "Water
Fill with Water" section.
9. Reinstall the humidifier cartridge and the air inlet filter.
End of Operation
1. Switch off the appliance.
2. Disconnect the plug from the mains.
3. You intend to not use the appliance for some time?
Then empty the water tank! (Proceed as described under
1 - 7, in the section "Change the Water" section.) Let the
fan run for 20 minutes on HIGH. This helps to dry the
inside of the appliance.
4. You can store the power cable on the cord wrap.
Cleaning
WARNING:
• Always remove the mains plug before cleaning the
device!
• Make sure no water enters the openings of the unit
during cleaning. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
Housing
• Clean the outside of the device with a dry cloth without
any additives.
• If the device is very dirty wet a cloth with water and then
wipe the device dry once you have finished.
Water Tank
• Rinse the water tank with clean water.
• Wipe the water tank dry.
Humidifier Cartridge and Air Inlet Filter
Clean these parts carefully under slow-running water. Let
them dry completely before you put the parts back in place.
CAUTION:
Put the unit into operation only once it is completely
assembled.
English
35
18.11.16