Unpacking The Appliance; Putting Into Service; Using The Appliance - AEG LK 5689 Mode D'emploi

English
34
34
4 Fins
5 Lever
6 Carrying handle
7 Water tank lock
8 Water tank
9 Cable wrap
10 Humidifier cartridge
11 Air intake filter
Without illustration:
2 x Batteries of type R03 "AAA" 1.5 V

Unpacking the Appliance

1. Remove the device from its packaging.
2. Remove all packaging materials like foils, filling materials,
cable holders, and carton packaging.
3. Check the scope of deliveries for completeness.
4. If there are missing parts or obvious damage, do not use
the device. Return it to your retailer immediately.
NOTE:
There may still be dust or production remains on the
device. We recommend that you clean the device as
described under "Cleaning".
Position
The ideal position is a non-slip, flat surface.
Water
• Only use distilled or boiled, cold tap water without
additives.
CAUTION:
Do not fill the water tank with water from clothes dryers
and water with additives (such as scented oils, perfume,
softeners, or other chemicals). Doing so may damage
the appliance.
• Replace the water every 3 - 4 days, even if it has not yet
been used.
• Remove the water from the water tank if the appliance is
out of use for long periods.
Fill with Water
1. Place the device on its operation site.
2. Open the lock of the water tank located on the rear panel.
For unlocking, turn it counter-clockwise.
3. Pull out the water tank up to the stop.
4. Fill the water tank. When doing so, observe the following:
• Min. filling capacity of 1.5 litres (min),
• Max. filling capacity of 4.5 litres (max).
5. Slide the water tank back into the device.
6. Close the lock by turning it clockwise.
LK5689_IM

Putting into Service

Power Cord
Unwind the power cord from the cable wrap at the back of
the unit.
Electrical Connection
1. Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
2. Connect the device to a duly installed protective contact
socket. A signal will sound indicating that the appliance is
ready for use.
Fitting Batteries into the Remote Control
1. Open the lid of the battery compartment on the rear of
the remote control.
2. Insert 2 MICRO batteries of type R 03 "AAA" 1.5 V.
3. Please ensure the correct polarity. Details can be found in
the battery compartment.
4. Close the battery compartment.
Remote Control Range
The remote control has a range of approx. 10 meters. If this
range becomes shorter, the batteries must be changed.
• To use the remote control, point it at the sensor on the
front of the switch housing.
• Make sure there are no obstacles between the remote
control and the sensor.
• The angle of the remote control to the remote control
sensor should not exceed 30° to the right, left, up, and
down.

Using the Appliance

Basic Settings
• Open the fins when using the device. With closed fins,
the device does not work properly.
• The air cooler always starts in normal mode with low
speed.
• If you interrupt the operation without unplugging the
power cord, the previously set operating mode remains
stored.
Operation
You can operate the appliance using the remote control as
well as the buttons on the switch housing. The functions are
identical.
NOTE:
The LED´s on the switch housing indicate the settings.
ON / O FF Switch on / off
Use the ON / OFF button to switch the appliance on or off.
18.11.16