Operating Determinations; Operation: El Wire 10M; Operation: El Wire 2M - EuroLite EL Wire Mode D'emploi

This device falls under protection-class III. The device always has to be operated with an appropriate
EL Wire 10m)
transformer (
Always disconnect from the mains or remove the batteries, when the device is not in use or before cleaning it.
If there are reasons for supposing that risk-free operation is no longer possible, the lighting chain must be
deactivated and protected against accidental operation. Risk-free operation can no longer be supposed when
the lighting chain
• no longer functions
• is visibly damaged
• has been stored long-term under adverse conditions, or
• has been exposed to stress during transport.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting chain for creating decorative effects.
EL Wire 10m
The is only allowed to be operated with an alternating voltage of 230 V, 50 Hz and may only be
operated with the included power unit. The power unit falls under protection-class 2 and the lighting chain
under protection-class 3.
EL Wire 2m
The is allowed to be operated with a direct current of 3 V and may only be operated with a
suitable set of batteries.
Do not shake the device. Avoid brute force when installing or operating the device.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
This lighting chain must never be electrically connected with another chain.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
OPERATION:
EL Wire 10m
In order to design the desired patterns, draw the form onto the surface or wrap the EL Wire around the
desired form and attach the EL Wire with adhesive tape or a few drops of glue.
Connect the power cable of the EL Wire to the transformer. Connect the transformer to the mains. Make sure
that the outlet is in a dry area.
On the controller of the EL Wire, you can find a 3-step switch with the following functions:
On Static light
Off Off
BI Blinking light
OPERATION:
EL Wire 2m
In order to design the desired patterns, draw the form onto the surface or wrap the EL Wire around the
desired form and attach the EL Wire with adhesive tape or a few drops of glue.
Open the battery cover and remove it. If replacing the batteries, remove the old batteries from the battery
compartment. Only replace complete battery-sets.
or with a suitable set of batteries (
8/18
EL Wire 2m).
00023918.DOC, Version 1.4