Location Of Controls - Clatronic HSM 3441 NE Mode D'emploi

• Do not repair the device by yourself. Please contact
authorized personnel. In order to avoid hazards, a
damaged mains cable must be replaced with an
equivalent cable by the manufacturer, our customer
service or any other qualified specialist.
• Do not operate the hair and beard clippers with wet
hands.
• Only cut dry hair with this unit.
• Only use this unit to cut head hair and beard.
• Do not press the clipper head too firmly onto the skin.
Danger of injury.
1 Suspension eye
2 On/Off switch
3 Hair length adjuster
4 Moving blade
GB
5 Fixed blade
Accessories (no illustration)
4 X Comb attachments (lengths: 3 mm, 6 mm, 9 mm, 12 mm)
1 X Protective cap for shaving head
1 X Cleaning brush
Adjust Cutting Length
• First remove the protective cap from the shaving head.
• Fit a comb attachment according to your desired hair length.The size of the hair length
setting is displayed in the center of the comb attachment.
• In order to fit a comb attachment, hold it with the teeth pointing upwards. The labeling
of the comb attachment should remain visible on the back. Slide the comb attachment
onto the shaving head and press it in so that it clicks into place.
48

Location of Controls