Publicité
CMS Series Columns
FIXED LENGTH EXTENSION COLUMN
The following procedure assumes that the ceiling plate/adapter
(accessory purchased separately) has been previously
installed. See instructions provided with plate/adapter.
NOTE:
Intended for use with Chief accessories and mounts.
1.
Install 1-1/2" NPT threaded column (A) into plate/adapter
(See Figure 1). Securely tighten column.
•
Ensure column (A) engages four full threads into
plate/adapter.
•
Ensure cable access opening is rotated to desired
position (optional installation).
NOTE:
Cable access opening provided on columns > 9"
(229mm) in length. Optional installation used when
cables must exit below plate/adapter.
2
A
1
4X
Figure 1
2.
Secure column (A) by tightening set screw in plate/adapter
(See Figure 1).
NOTE:
Hex key and set screw provided with plate/adapter.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components attached to the CMS Series Extension
Column does not exceed 500 lbs (226 kg).
•
The weight capacity of the CMS Series Extension
Column may be LIMITED to the lowest weight capacity
of any other component located between the CMS
Series Extension Column and the supporting structure!
3.
Install and secure projector/display mount to lower end of
column (A). See instructions provided with mount.
6
ADJUSTABLE LENGTH EXTENSION
COLUMN
The following procedure assumes that the ceiling plate/adapter
(accessory purchased separately) has been previously
installed. See instructions provided with plate/adapter.
NOTE:
Intended for use with Chief accessories and mounts.
1.
Install 1-1/2" NPT threaded column (A or B, as applicable)
into plate/adapter (See Figure 2). Securely tighten column.
•
Ensure column (A or B, as applicable) engages four full
threads into plate/adapter.
•
Ensure cable access opening is rotated to desired
position (optional installation, column (A)).
NOTE:
Cable access opening provided on columns > 9"
(229mm) in length. Optional installation used when
cables must exit below plate/adapter.
2
B
1
4X
3
A
2.
Secure column (A or B, as applicable) by tightening set
screw in plate/adapter (See Figure 2).
NOTE:
Hex key and set screw provided with plate/adapter.
3.
Install mating column (A or B, as applicable) (See Figure 2).
Installation Instructions
A
1
1
4X
4X
3
B
Figure 2
Publicité
