Pulsing And Gliding - Silk-n Motion Instructions D'utilisation

8.3 Pulsing and gliding

EN
Pulsing is the best technique for working at higher energy levels.
Press the treatment surface against your skin. Work in rows
(either across or down as shown in the image). Start at one end
of each row and progress to the other end.
The treatment surface creates temporary pressure marks on the
treated area so you can see areas you have treated.
After each pulse, move the treatment surface to the next spot.
Keep doing this pulsing action for the area you are treating.
Avoid gaps or overlaps as you use the device.
Gliding is the best technique for working at lower energy levels.
Press the treatment surface firmly against your skin and slowly
glide over your skin (either across or down as shown in the
image). Make sure that the treatment surface is always touching
your skin.
At lower energy levels, the device takes only 1-1.5 seconds to
recharge between pulses. This generates a nonstop sequence
of flashes.
Glide at a speed so that you avoid gaps or overlaps.
E
Do not treat the same area of skin more than once per hair removal
session.
E
Stop use immediately if you have any discomfort.
12