Fault Code - AEG AXP26U338CW Manuel D'utilisation

To cancel the setting, press the "timer"
button again.

7.3 Fault code

If the display reads "AS", "CS" and
"ES", the temperature sensor has failed.
Contact your Authorized AEG
Service Center.
If the display reads "L3", the condenser
DC fan motor has failed. Contact your
Authorized AEG Service Center.
If the display reads "P1", bottom tray is
full. Carefully move the unit to a drain
location, remove the bottom drain plug
and let the water drain away. Restart the
machine until the "P1" symbol disappears.
If error repeats, call for service.
If the display reads "E4", the
communication between display PCB and
main control PCB is faulty. Contact your
Authorized AEG Service Center.
7.4 Drainage instruction
Continuous Drainage
During the DRY mode or heat pump
model, you will need a garden hose
(sold separately) or drain hose to
drain the condensate from the unit.
Follow the steps below:
• Unscrew the drain cap of continuous
drain outlet(Fig.20).
• Connect one end of the garden hose
(sold separately) or drain hose to
the drain outlet then lead the other
end into a drain that is lower than the
unit(Fig.21).
NOTE:
•
the drain cap, if the unit is running in
Cool or Auto mode. When you want
to remove the garden hose, prepare
a drip tray (not supplied) to collect the
condensate from the drain outlet.
• Please be sure that the height of the
drain and section of the drain hose
should not be higher than that of the
drain outlet, or the continous drainage
may not work properly.
• During Cool or Auto mode, it is
recommended to disable continuous
drainage by replacing the drain cap to
the drain outlet, to reach the maximum
performance.
ENGLISH 19
Fig. 20
Drain cap
for Dry mode
Drain cap
for Heat Pump mode
Garden hose
Drain hose
Fig. 21