Troubleshooting Guide - EINHELL GE-CM 36/37 Li Mode D'emploi D'origine

The reprinting or reproduction by any other
means, in whole or in part, of documentation and
papers accompanying the products is strictly
subject to the express consent of iSC GmbH.
Subject to technical changes.

10. Troubleshooting guide

Error
Motor does not a) Motor terminals disconnected
start
b) Machine standing in high grass
c) The mower housing is clogged
d) Safety plug is not inserted
e) Battery is not correctly inserted
Motor a) Grass too tall or damp
performance b) The mower housing is clogged
drops
c) Blade badly worn
d) Battery performance decreasing
Unclean cuts a) Blade worn
b) Wrong cutting height
Important! For protection, the motor is equipped with a thermal switch which cuts out when
the motor is overloaded and switches on again automatically after a short cooling period.
Anl_GE_CM_36_37_Li_USA.indb 18 Anl_GE_CM_36_37_Li_USA.indb 18
EN
Possible cause
- 18 -
Remedy
a) Have it checked by a customer service
workshop
b) Start motor on shorter grass or already
mowed area; change cutting height if
necessary
c) Clean housing so that the blade can
run freely
d) Insert the safety plug (see 6.)
e) Remove the battery and reinsert
(see 5.)
a) Correct the cutting height
b) Clean the housing
c) Replace the blade
d) Check the battery performance and
charge the battery if necessary (see 5.)
a) Replace or resharpen the blade
b) Correct the cutting depth
23.09.2020 11:17:46 23.09.2020 11:17:46