Installation Procedure - Toto ZA TLP03301U Manuel D'installation Et D'utilisation

Faucet
1. Place gaskets under spout.
Pass the supply hoses and mounting
studs through the mounting holes
until the spout comes to rest.
2. Orient the spout as needed.
From below the mounting surface,
place the crescent shaped washer
over the mounting studs as shown.
Fasten the mounting nuts to the studs
to secure the spout.
Tighten with wrench as needed.
Connect the hoses to the supply lines.
The left hose (marked with red band)
connects to the hot water supply. The
right hose connects to the cold water
supply.
Tighten with wrench as needed.

INSTALLATION PROCEDURE

Section View
4
Hot water
supply hose
Spout Body
Gasket
Mounting Studs
Hot water
supply hose
Washer
Spring washer
Mounting Nut
Spout Body
Cold water
supply hose
Cold water
supply hose