Electrolux WHGL9040CN Mode D'emploi page 6

www.electrolux.com
6
4. CONTROLS
Button
L
T1
T2
T3
T4
T5
F
5. LIGHTING
Warning: This appliance is fitted with a
white LED lamp classed as 1M according
to EN 60825-1: 1994 + A1:2002 + A2:2001
standards; maximum optical power emitted
@439nm: 7µW. Do not look directly at the light
through optical devices (binoculars, magnifying
glasses...).
• For replacement contact technical support.
("To purchase contact technical support").
L T1 T2 T3 T4 T5 F
Basic function
Dual Function
Press briefly to turn the lighting system on and off.
Press and hold the button for 2 seconds to activate the lighting
system in "courtesy light" mode. The lights are lit at a reduced power
of approximately 5W. This function can be disabled by pressing the
button once again for 2 seconds or by pressing it briefly to switch to
normal lighting mode.
Turns the motor off from whatever speed it is set to.
Press and hold the button for 3 seconds with all the loads turned off
(Motor and Lights), to turn the Activated Charcoal Filter alarm on/off.
Turns the motor on at speed one.
When pressed briefly, turns the motor on at speed two.
Press and hold the button for approximately 2" to turn the Delay
function on and off, that is to say to turn the appliance off after a 20
minute delay. Suitable to complete elimination of residual odours. Can
be activated from the OFF position and from speeds 1, 2, 3. Cannot
be activated with Intensive speed On.
Turns the motor on at speed three.
Turns the motor On and Off at Intensive speed for a timed
period of 5 minutes. At the end of the 5 minutes the appliance
will automatically return to the speed that was set before. If the
appliance was turned off at the time of activation, at the end of
the 5 minutes the system will return to speed one.
Press and hold for 4 seconds to reset the filter alarm indicator,
shown by flashing of button T1. This procedure can only be
carried out with the motor off.
Indicator lights
Button off Lights off
Button lit Lights on
Button lit Courtesy light on
Button lit Motor active
Motor inactive
Button flashes twice F – Alarm On.
Button flashes once F – Alarm Off.
Button on
Button on Speed two on
Buttons flashing
(T1+T2 or T3
Delay functionActive
or T4)
Button on
Button on
Signals the Metal Grease Filter
saturation alarm, indicating that it is
necessary to wash the filters. The
Button on
alarm is triggered after the Hood
has been in operation for 100
working hours.
When this is activated, it
signals the Activated Charcoal
Filter saturation alarm, indicating
that the filter must be changed;
the Metal Grease Filters must
Button flashing
also be washed. The Activated
Charcoal Filter saturation alarm
comes into operation after the
Hood has been working for
200 hours.