Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation • Installation
9.2.2 Retaining bracket
The appliance is supplied with a retaining bracket to prevent
the wall mounted appliance from moving or tilting.
Two mounting holes for the retaining bracket are already pre-
punched into the rear panel. These mounting holes are each
provided with a fixing screw for the retaining bracket.
1 Pre-punched mounting hole
2 Retaining bracket
3 Fixing screw
- If you mount the appliance horizontally, attach the retain-
ing bracket to the long edge of the appliance.
- If you mount the appliance vertically, attach the retaining
bracket to the short edge of the appliance.
9.2.3 Wall mounting bracket installation
Note
Use the wall mounting bracket as a drilling template
when marking the fixing holes.
f Attach the wall mounting bracket to the wall
f
using one horizontal slot and one vertical slot.
Note
The screws and rawl plugs are not part of the standard
delivery.
f Use appropriate fixing materials.
f
f Determine the position of the appliance. Mark the centre
f
of the top edge of the appliance on the wall.
f Starting from the centre of the top edge of the appliance,
f
mark the fixing holes for the wall mounting bracket on the
wall.
f Drill the fixing holes for the wall mounting bracket.
f
f Secure the wall mounting bracket on the wall.
f
f Adjust the position of the wall mounting bracket until it is
f
horizontally level. The horizontal and vertical slots in the
wall mounting bracket enable alignment if drilled holes
are not completely accurate.
© wodtke GmbH - Tübingen.
1
3
2
IR_BA_190726
9.2.4 Fitting the retaining bracket
1
1 Retaining bracket
f Attach the retaining bracket to the rear panel using the
f
fixing screw provided.
2
1 Wall mounting bracket
2 Retaining bracket
Material losses
!
Ensure that the power cable is not pinched or dam-
aged when you hook in the appliance.
We recommend that you fully extend the power cable
before wall mounting.
f Hook the appliance centrally onto the wall mounting
f
bracket.
f Mark the fixing hole for the retaining bracket on the wall.
f
f Lift the appliance off the wall mounting bracket.
f
f Drill the fixing hole for the retaining bracket.
f
9.2.5 Hooking the appliance into place
f Hook the appliance centrally onto the wall mounting
f
bracket.
f Lock the appliance in by securing the retaining bracket to
f
the wall.
1
Page 17 / 64
Publicité
Chapitres
Table des Matières
Dépannage
