Before Use - Teac AI-301DA Mode D'emploi

V
CAUTION
Placement of the unit
o Do not put anything on top of the unit.
o Avoid placing the unit in direct sunlight or
close to any source of heat, such as a radia-
tor, heater, open fireplace or amplifier. Also
avoid locations that are subject to vibra-
tions or exposed to excessive dust, cold or
moisture.
o Place the unit in a stable location near the
audio system that you will use with it.
o As the unit could become warm during
operation, always leave sufficient space
around it for ventilation. When installing this
unit, leave a little space (at least 5 cm or 2")
between it and walls and other devices in
order to allow good heat dissipation. When
placing it in a rack, for example, leave at least
5 cm (2") open above it and 10 cm (4") open
behind it. Failure to provide these gaps could
cause heat to build up inside and result in
fire.
o You may stack this unit with a UD-301 or
other H01 series units. However, if heat
should cause the protection circuit to be
activated and sound output stops suddenly,
place this unit on top and with sufficient
distance between it and walls and other
devices in order to improve heat dissipation.
o Do not move the unit during use.
o The voltage supplied to the unit should
match the voltage printed on the rear panel.
If you are in any doubt regarding this matter,
consult an electrician.
o Do not open the body of the unit as this
might result in damage to the circuitry or
cause electric shock. If a foreign object
should get into the unit, contact your dealer.
o When removing the power plug from the
wall outlet, always pull directly on the plug;
never yank on the cord.

Before Use

o If a TV is turned on while the unit is on, static
might appear on the TV screen depending
on the characteristics of the TV broadcast
signal. This is not a malfunction of the unit
nor of the TV. If this occurs, put the unit into
standby.
Maintenance
If the surface of the unit becomes dirty, wipe it
with a soft dry cloth. If the unit becomes very
dirty, dampen a soft cloth slightly with a diluted
neutral cleanser and thoroughly wring out any
excess fluid before using the cloth to wipe the
unit.
V
For safety, disconnect the power
cord from the outlet before cleaning.
o Never spray liquid directly on the unit.
o Do not use thinner or alcohol as they could
damage the surface of the unit.
o Avoid allowing rubber or plastic materials to
touch this product for long periods of time,
because they could damage the cabinet.
9