Applications; Conformity And Approval; Power Supply Unit - Monacor ATS-16R Mode D'emploi

•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly operated or not repaired in an ex-
pert way.
If the unit is to be put out of operation
definitively, dispose of the unit in ac-
cordance with local regulations.

3 Applications

In combination with a receiver or several receiv-
ers of the type ATS-16R, the transmitter ATS-16T
creates a mobile wireless transmission system for
speech and music. This system is ideally suited for
any application where the signal of a single audio
source is transmitted to several people, e. g. for
guided tours or multilingual lectures. For wireless
transmission, 16 channels in the frequency range of
863 – 865 MHz are available.

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the receiver ATS-16R and the transmitter ATS-16T
comply with the directive 2014 / 53 / EU. The EU dec-
larations of conformity are available on the Internet:
www.monacor.com
The units are generally approved for operation in
EU and EFTA countries. The operation of the units is
licence-free and requires no registration.
4 Power Supply
The transmitter and the receiver can be supplied
with power via (rechargeable) batteries or a 5 V

power supply unit.

4.1 (Rechargeable) Batteries
Each unit is supplied with two rechargeable 1.2 V
NiMH batteries. For fast and convenient charging of
these batteries, the following items are available as
accessories:
– charging station ATS-16PS
(for charging the batteries of up to 2 transmitters /
receivers at the same time)
– transport and charging case ATS-36C
(for charging the batteries of up to 36 transmit-
ters / receivers at the same time)
Instead of the rechargeable batteries, two non-re-
chargeable 1.5 V batteries of size AA may be used.
To insert the batteries:
1) Slightly press the marked area on the battery
compartment cover (8) while simultaneously
pulling the cover downwards.
2) Insert the batteries with their positive and neg-
ative connections as indicated in the compart-
ment.
3) Replace the cover and make sure it engages.
Never put batteries in the household
waste. Always dispose of the batteries
in accordance with local regulations.
4.2 Power supply unit
Connect a power supply unit with an output voltage
of ⎓ 5 V and a permanent rating of 150 mA to the
jack DC IN 5V (11). For connection, a low-voltage
plug of the dimensions 3.5 / 1.3 mm (outside / inside
diameter) is required. The positive pole must be at
the inside contact of the plug.
Attention: To prevent damage to the batteries
or to the transmitter / receiver, always remove the
(rechargeable) batteries from the battery com-
partment before connecting a power supply unit.
9