Important; Electrical Connection - Sacopa ONLED RGBW-DMX Manuel D'installation Et D'entretien

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Projector RGBW-DMX, follow the instructions provided below:

1. ELECTRICAL CONNECTION

The projectors are supplied with a 2-wire 1.5mm
H05RNF cable with 2 x 1mm
Under no circumstances must the power supply be above 24V DC.
This projector has been designed to operate only with a DMX control and with the DMX power supply (code
I0832DMXI52 and I0832DMXFEI52). It doesn't work with any other control system.
2. CONTROL SYSTEMS OF THE RGBW-DMX LED PROJECTORS
RGBW-DMX projectors use 4 DMX channels (red, green, blue and white). The configuration of DMX direction is realized
from the DMX Power Supply code I0832DMXI52 or I0832DMXFEI52. The Power supplies achieve to connect until a
maximum of 60W for I0832DMXI52 and until 400W for I0832DMXFEI52. The Power supply has 6 point outputs, which it
is indifferent what of them are connected the projectors.
I0832DMXI52 and I0832DMXFEI52 power packs can handle up to 6 x RGBW-DMX (24 DMX channels) spotlights con-
trolled independently so long as maximum line power is not exceeded.
Internal power supply (P.Máx=60W)
External power supply (P.Máx=400W)
DMX IN/OUT
- +
+ - + - + - + - + - + -
OUTPUT FOR DMX PROJECTORS
2
Cu H07RNF cable. Except the Escala flood lights which come with
2
Cu wires.
DMX LINE
- +
TERMINATION
See manual of the DMX mains lead
code I0832DMXI52 for information
addresses to each projector and
For 4 Channel RGBW projectors
projector and how to configure
For 4 Channel RGBW projectors
24V DC
3
regarding how to assing DMX
how to configure a system.
use the F-4 or F-9 mode, in F-1
mode does not work.
See manual of the DMX mains
lead code I0832DMXFEI52 for
information regarding how to
assing DMX addresses to each
system.
use the F-4 or F-9 mode, in F-1
mode does not work.
a