Additional Spool Pin - ELNA eXperience 660 Mode D'emploi

t
y
u
t Push bobbin winder spindle to the right. The
computer display screen will show a bobbin winding
message.
y Holding the free end of the thread, press the foot
control or Start/Stop key. Stop machine after the
bobbin has made a few turns. Cut the thread tail
close to the hole in the bobbin. Start machine again
to continue winding bobbin. When the bobbin is fully
wound, stop the machine.
u Move the spindle to the left to return the bobbin
winder to its original position. Cut the thread as
shown.

Additional Spool Pin

The additional spool pin can be used to wind an extra
bobbin without unthreading the machine.
t
PROCEDURE: Insert the spool stand w and the
r
e
w
q
23
additional spool pin e in the hole q.
Place the felt r and spool t on the pin
with the thread coming off the spool as
shown.