Connecting Machine To Power Supply - ELNA eXperience 660 Mode D'emploi

e
w

Connecting Machine To Power Supply

q
Before connecting the power cord, make sure the voltage
and frequency shown on the machine are identical to
your electrical power.
To connect machine to power supply, turn off the power
q
switch
e
plug into the machine and the power supply plug
into the wall socket.
Your machine may come equipped with a polarized plug
(one prong wider than the other). A polarized plug
reduces the risk of electrical shock. This plug is intended
to fit into a polarized outlet. If the plug does not fit fully
into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
r
IMPORTANT: When using your sewing machine the first
NOTE: After turning off the machine, wait 5 seconds
before turning it on again.
For Your Safety
Do not use extension cords or plug adapters.
Do not touch plug with wet hands.
Always turn off the power/light switch first and then
unplug from the electrical outlet. Examples:
• when leaving the machine unattended
• when cleaning the machine
Always turn off the power/light switch:
• when attaching or removing parts such as needle,
presser foot, needle plate
• when threading needle or bobbin
Do not place anything on the foot control.
Do not place heavy items on cords. Do not subject cords
to heat. Do not use damaged cords. Have the cord
repaired immediately.
While the machine is in operation, always keep your eye
on the sewing area and do not touch any moving parts
such as the thread take-up lever, flywheel or needle.
9
. Insert the foot control plug
few times, place waste fabric under the
presser foot and run the machine without
thread for a few minutes. Wipe away
excess oil.
w
and machine
r