3
Assemble 2 left legs, 1 right rear leg and 1 right front leg to firebox and bottom shelf . Use four 1/4-20 x 2 ½ "screws
for the bottom shelf and eight 1/4-20 x 3/4" screws for firebox, tighten screws as shown in the figure.
Note: For easier assembly, lay grill with its front panel to the floor, attach the front legs, and then flip over onto its
back panel to attach the back legs
Note: When attaching legs, make sure that the top 2 holes on right legs are facing each other.
1/4- 20 x 3/4" screws
(8 pieces)
Leg,left front/rear
(2 pieces)
4
Set the grill upright, insert the wheel axle into left legs holes and assemble the two wheels. Install two 23.5
mm dia. washers onto axle. Insert large hitch pins into wheel axle holes. (Smaller hitch pins are for the lid.)
Wheels
23.5 mm dia. washer
Large hitch pin
Bottom shelf
Wheel axle
Leg, right rear
1/4- 20 x 2 1/2" screws
(4 pieces)
Leg, right front
Page 9