Table des Matières
Publicité
C-4
(MC-CG887)
C-5
Suction control
Régulateur d'aspiration
Control de aspiración
C-6
C-7
12
C-HOW TO OPERATE YOUR CLEANER
(MC-CG885)
Decrease
Increase
suction
suction
Diminution de
Augmentation
l'aspiration
de l'aspiration
Disminuir
Aumentar
aspiración
aspiración
Performance
indicator
Indicateur de
performance
Indicador de
rendimiento
C-4
Select a switch position on the handle.
OFF
FLOOR: turns on the canister motor only.
CARPET: turns on both the canister and the power
nozzle motors and turns on the canister
headlight
Adjust the power level (Only MC-CG887).
Sliding the switch to adjust the power.
NOTE: When this switch is in the FLOOR position, the headlight
and dirt sensors DO NOT function since no electricity
flows to the power nozzle.
C-5
SUCTION CONTROL
The suction control allows you to change the vacuum
cleaner suction for different fabrics and carpet weights.
Opening the control decreases suction for draperies
and lightweight rugs, while closing the control increases
suction for upholsteries and carpets.
C-6
PERFORMANCE INDICATOR
When the vacuum cleaner is running with normal
airflow, color on the performance indicator is clear.
The red color comes on whenever the airflow becomes
blocked. If that occurs, check the disposable dust bag,
pre-motor filter and other possible clog locations.
C-7
STORAGE POSITION
Slide the wand holder attached to the nozzle pipe
straight into the wand supporter on the left side of the
canister bottom.
CAUTION
DO NOT leave the Power nozzle running in one spot in
the upright position for any length of time.
Damage to carpet may occur.
Note: Refer to your carpet manufacturers cleaning
recommendations. Some more delicate carpets
may require that they be vacuumed with the
Power nozzle agitator turned off to prevent carpet
damage.
Publicité
Table des Matières
