Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions – HA3MR Installation and Lamping Instructions
INSTALLATION
Fixture
1.
Open fixture top and remove transformer from packing
material.
2.
Install transformer on mounting bracket. (Figure 1.) Slide
unsleeved wires through slot in J-box cover.
3.
Install fixture into ceiling using 1/2" electrical conduit,
3/4" channel, 1-1/2" channel, 1/8" x 1/2" bar stock,
or T-bar mounting rails (by others) by inserting them
through hanger bar brackets at both sides.
4.
Adjust height of fixture so that the plaster ring is flush
with finish ceiling line.
WARNING
This fixourt as shipptd is wirtd fNr 120V inpuo. Io can
bt Nptraotd ao 277V inpuo by rtwiring oransfNrmtr in
juncoiNn bNx. (Figurt 2.)
5.
Connect supply wires to leads in junction box in
accordance with local electrical codes or N.E.C.
Lamp
1.
Insert lamp into lampholder bracket/lens assembly.
2.
Determine if relamping is to be done from below or
above the ceiling. Install lamp and lens assembly in
proper position. (Figure 3. and Figure 4.)
Slide Transformer Feet Through Slot on Mounting Bracket Until
Spring Snaps Into Place.
Figurt 1.
2
Figurt 2.
Figurt 3.
Figurt 4.
InsoallaoiNn InsorucoiNns – HA3MR InsoallaoiNn and Lamping InsorucoiNns
IB520051ML
277 V
120 V
COMMON
Relamp From Above
Relamp From Below
www.eaton.com
BLUE
LAMP
BLUE
Publicité
