Lubricating Time Setting; Operational Test; To Trigger An Additional Lubrication Cycle - Lincoln Quicklub 236-13891-1 Instructions De Service

User Manual
Operating Instructions
PCB 7 Rotary switch for lubricating time, red
Switch position 1
Seconds 8
Minutes
2
Operational Test / To Trigger an Additional Lubrication Cycle
PCB 8 Components of the control p.c.b.
1 - LED, left-side
2 - Rotary switch to set pause time
3 - LED, right-side
4 - Rotary switch to set lubricating time
5 - Pushbutton to trigger additional lubrication cycle
Page 6 of 20
LINCOLN GmbH • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
T -PCBv-0 20e08
2 3 4 5
16 24 32 40
4 6 8 10
T-PCBv-020f08

Lubricating time setting

The lubric ating tim e can be set to 15 different settings by
mans of the red rotary switch.
Depending on the position of the jumper (see fig. PCB 5
the necess ary tim e interval is adjustable (8-120 seconds or
2-30 minutes).
NOTE
During switching position 0 a failure report
at the light emitting diode takes place on the
right LED 3 (see fig. PCB 8).
At the same time the factory-set lubricating
6001a02
time is accepted.
6 7 8 9
48 56 64 72
12 14 16 18
Switch on the power supply (machine contact / driving
switch).
To check whether power is applied to the printed circuit
board, obs erve whether the LED 1 is lit.
To check the pum p operation it is possible to perform an

operational test.

Pr ess illum inated pushbutton 5 on p.c.b. > 2 sec. until the
right-side LED 3 is lit.
Then the pause time lapses shorter and is followed by a
normal lubrication cycle.
Additional lubrication cycles are possible at any time by
triggering the illuminated pushbutton.
2.6EN-28006-A09
A B C D
80 88 96 104
20 22 24 26
E F
112 120
28 30