Makita 2414NB Manuel D'instruction page 5

The original spacing or interval between the vise and the
guide plate is 0 - 170 mm (0 - 6-11/16"). If your work
requires wider spacing or interval, proceed as follows to
change the spacing or interval.
Remove the two hex bolts which secure the guide plate.
Move the guide plate as shown in the figure and secure it
using the hex bolts. The following interval settings are
possible:
35 - 205 mm (1-3/8" - 8-1/16")
70 - 240 mm (2-3/4" - 9-7/16")
CAUTION:
• Remember that narrow workpieces may not be
secured safely when using the two, wider interval
settings.
Setting for desired cutting angle
3
To change the cutting angle, loosen the two hex bolts
which secure the guide plate. Move the guide plate to the
desired angle (0° - 45°) and tighten the hex bolts
securely.
CAUTION:
• Never perform miter cuts when the guide plate is
set at the 35 - 205 mm (1-3/8" - 8-1/16") or 70 - 240
mm (2-3/4" - 9-7/16") position.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
003759
003760
1. Socket wrench
1
2. Guide plate
2
3. Hex bolts
Removing or installing cut-off wheel
1
To remove the wheel, raise the safety guard. Press the
shaft lock so that the wheel cannot revolve and use the
socket wrench to loosen the hex bolt by turning it coun-
terclockwise. Then remove the hex bolt, outer flange and
wheel. (Note: Do not remove the inner flange, ring and O-
ring.)
To install the wheel, follow the removal procedures in
reverse.
1
2
3
4
CAUTION:
• Be sure to tighten the hex bolt securely. Insufficient
tightening of the hex bolt may result in severe injury.
Use the socket wrench provided to help assure
proper tightening.
• Always use only the proper inner and outer flanges
which are provided with this tool.
• Always lower the safety guard after replacing the
wheel.
Securing workpiece
1
By turning the vise handle counterclockwise and then
flipping the vise nut to the left, the vise is released from
the shaft threads and can be moved rapidly in and out. To
grip workpieces, push the vise handle until the vise plate
5
003761
2 1. Shaft lock
2. Safety guard
3
3. Socket wrench
003762
1. O-ring
7
2. Inner flange
3. Ring
4. Spindle
5. Cut-off wheel
6. Outer flange
6
7. Hex bolt
5
003763
1. Vise plate
2. Vise nut
2
3. Vise handle
3