Emptying The Water Reservoir; Overheating Protection; Cleaning, Care & Maintenance - Buffalo CT815 Mode D'emploi

UK
Using the top hotplate
This appliance is fitted with a second hotplate to
keep an additional jug warm. To use:
1. Place the jug on the top hotplate.
2. Turn the power switch
hotplate.
3. Ensure to turn the top hotplate off when not in
use.
Warning!
The surrounding surface of the
hotplate may become hot. DO
NOT touch! Never heat an empty
Jug on the hotplate, or allow the
Jug to run dry.

Overheating protection

This appliance is featured with overheating
protection. Should the temperature exceed safe
levels the appliance will automatically cut off
power.
Caution!
In case the protection against
overheating is activated, please
let the appliance cool and press
the RESET button on the back.
Cleaning, Care &
Maintenance
Warning!
• Turn off and disconnect
the appliance from the
power supply. Allow to cool
sufficiently before cleaning
and maintenance.
• Prior to cleaning, moving or
transporting the appliance,
ensure to empty the water
reservoir.
6
CT815_ML_A5_v3_20210218.indb 6 CT815_ML_A5_v3_20210218.indb 6

Emptying the water reservoir

• A small amount of water (approx. 0.5L) will
always remain in the appliance. Do not tip over
after use to drain water.
• The remaining water should only be drained
using the drain screw at the back of the device.
On for the top
• Re-tighten the water drain screw firmly
afterwards.
Cleaning
• Use soapy water and a damp cloth to clean the
exterior of the appliance.
• Wash the glass jug and filter basket with warm
soapy water. Then rinse with clean water.
• Dry thoroughly after cleaning.
Drain screw
Warning!
DO NOT loosen the water drain
screw during operation or shortly
after use! Risk of scalding!
Caution!
Clean the device regularly and
remove any lime scale. Refer to
the instructions on next page for
descaling details.
2021/2/18 16:36 2021/2/18 16:36