Urmet 1093/182WM1 Guide Rapide page 15

4.3 STATIC IP ADDRESS ALLOCATION
The network parameters of the camera, such as IP address, subnet mask and gateway may be
set and modified using
It is advisable to set a static IP address after having appropriately connected and configured the
camera in the network (see previous sections). Make sure that the IP address you want to assign
to the camera is not already used in the network. It is better to use an address outside the range
of addresses assigned by means of DHCP.
To assign the static IP address, select the camera after having detected it in
shown in the figure below, fill in the static network parameter to be assigned (the fields are filled
in automatically by selecting the correct network interface from those available on the PC) in the
specific section of the tool.
"
Press Modify IP Address
for a few instants.
"
Press the Refresh List
with the changes made.
IMPORTANT NOTE: set/edit the network parameters of the camera (IP address, subnet mask,
gateway) is advisable to use EasyTool or the web page of the camera. It is advisable to set/edit
the network configurations of the camera in the NVR/HVR menus on which the camera was
added or check that the NVR/HVR device is updated to the latest firmware version.
Quick guide and complete user manual of the product are available at the
following link
Quick guide and complete user manual of the product are also available for DOWNLOAD from the URMET
website under the section USER MANUALS.
DS1093-559
" "
EasyTool provided or on the camera web page.
"
(Modifica indirizzo IP) to change the IP address of the device and wait
"
(Aggiorna) button of
" "
EasyTool to refresh the list and view the camera
" "
EasyTool . As
15