Making The Electrical Connection - Stiebel Eltron DNM 3 Utilisation Et Installation
Masquer les pouces
Voir aussi pour DNM 3:
- Utilisation et installation (61 pages) ,
- Utilisation et installation (172 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Installation
f Hook in the appliance cover with the heater at the bottom.
f
f Click the heater into place using the snap fastener.
f
f Secure the appliance cover with the cover fixing screws.
f
Tap installation
Material losses
!
When making the connections, counter the torque on the
appliance using a size 14 spanner.
f Install the tap. For this, also observe the tap operating and
f
installation instructions.
10.2.2 Oversink installation, non-pressurised, with non-
pressurised tap
www.stiebel-eltron.com
Tap installation
f Install the tap. For this, also observe the tap operating and
f
installation instructions.
Material losses
!
f When making the connections, counter the torque
f
on the appliance using a size 14 spanner; see chap-
ter "Installation alternatives / Undersink installa-
tion".
Appliance installation
f Fit the appliance to the tap with the water connections.
f
10.3 Making the electrical connection
DANGER Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
DANGER Electrocution
Ensure that the appliance is earthed.
Ensure the appliance can be separated from the power
supply by an isolator that disconnects all poles with at
least 3 mm contact separation.
DNM |
33
Publicité
Chapitres
Table des Matières
Dépannage
