Before Using For The First Time; Control And Display Elements; Safety Devices; Base Unit - Bosch SmartPower MFW25 Série Mode D'emploi

en

Before using for the first time

Before using for the first time
Before the new appliance can be used,
it must be fully unpacked, cleaned and
checked.
Caution!
Never operate a damaged appliance!
■ Remove the base unit and all
accessories from the packaging.
■ Remove the packaging material that is
present.
■ Dismantle any assembled parts into
their individual parts. Do this in reverse
order, as described under „Preparation".
■ Check all parts for completeness.
X Fig. A
■ Inspect all parts for visible damage.
■ Thoroughly clean and dry all parts
before using for the first time.
X "Care and daily cleaning" see
page 21
Control and display
elements
Button k
Press button k to switch on the appliance.
The drive will start up at once. Press button
k again to switch off the appliance. The
drive stops.
Release button
Press the release button to unlock an
attachment fitted on the appliance. Only
when the release button is pressed is it
possible to turn the attachment clockwise
and remove it from the base unit.

Safety devices

Overload protection
(thermal circuit breaker)
If the motor switches itself off while the
appliance is being used, the overload
protection feature has been activated.
Possible causes may be the simultaneous
processing of large quantities of food or a
blockage caused by bones.
X "Troubleshooting" see page 25
18

Base unit

Preparation
W Risk of injury!
Do not insert the mains plug until all
preparations for working with the appliance
are complete and the required attachments
are assembled correctly and connected to
the base unit.
■ Place the base unit on a stable and level
work surface.
The base unit is now prepared.

Base attachment

The base attachment can be used for the
following applications:
Meat mincer
For mincing raw or cooked food. Select the
appropriate perforated disc depending on
the type and consistency of the food to be
processed. X "Tips" see page 23
Sausage filler
For filling artificial and natural casings with
sausage meat. For producing meat rolls.
Kebbe maker
For producing tubes of dough or minced meat.
Note: Other applications are possible
using the base attachment and appropriate
accessories available from Customer
Service.
Caution!
When assembling the different individual
parts, make sure that the notched markings
on the inserts match up with the relevant
one on the housing.
Preparation for meat mincer
W Risk of injury!
Do not reach into the sharp knife.
Caution!
Always only use one perforated disc.
X Fig. B
1. Insert the worm gear with the agitator
paddle at the front in the housing.