Boiler Use; Introduction; Description Of Control Panel - Ferroli NATURFIRE 30 HR Manuel D'installation, D'utilisation Et D'entretien

4

BOILER USE

4.1 Introduction

The pellet boiler has the advantage of combining the heat generated by the combustion of wood with the
convenience of automatic water temperature management and the possibility of weekly programming of switching
on/off, as well as the connection of a thermostat and/or chronothermostat and start-stop remote control.
For safe and reliable use:
- when lighting and using the unit the first time, unpleasant odours may be created, therefore air the room
thoroughly;
- the hopper must only be filled with good quality pellets; make sure the bag does not come into contact with the hot
surfaces of the boiler;
- do not put any fuel other than the prescribed pellets in the hopper;
- the unit must not be used as a waste incinerator;
- the boiler must only operate with the fire door always closed.
- the fire and ash door seals must be checked periodically to prevent air from entering;
- to ensure thermal efficiency and correct operation it is necessary to clean the brazier every time pellets are loaded;
- when lighting the boiler for the first time, allow it to heat up gradually by setting low operating temperatures (see the
section on temperature setting);
- during lighting, operation and shutdown, the boiler may creak a little due to the heat expansion.

4.2 Description of control panel

The control panel comprises a backlit LCD, on/off button 'P4', SET/MENU button 'P3', four menu buttons 'P1', 'P2',
'P5', 'P6', and seven boiler operation status LEDs.
Top display indications
Setting
and selection
buttons
The panel enables boiler lighting and shutdown, adjustment during operation and the setting of management and
maintenance programs.
The display shows all the information on boiler operation status.
To access the menus, proceed as follows:
- press the SET button 'P3';
- press the buttons 'P5', 'P6' to scroll the various menus;
- press one of the increase/decrease buttons 'P1', 'P2', to set the required parameter;
- press the SET button 'P3' to confirm the parameter value.
On accessing the menu it is possible to obtain the various types of displays and make settings, depending on the
access level.
Status indicators
Backlit LCD
Bottom display indications
54
Top display indications
Setting buttons
On - selection
button
IR receiver
NATURFIRE 30-35-39 HR