Cleaning And Maintenance - Domo DO7346M Mode D'emploi

· Make sure there are no objects such as a shelf or a closet at less than 1 meter from the top of the
appliance.
· In the bathroom the appliance must be at least 60 cm away from the bath, washbasin or shower.
· The appliance can only be placed horizontally. The appliance will not work if you hang it vertically
against the wall. The appliance has a tip-over safety, which means the appliance will shut off
automatically when it falls over or when it is not placed horizontally.
· This heater is protected with an overheat protection that switches off the heater automatically in case
of overheat, e.g. due to the total or partial obstruction of the grids. The overheating shut-off switches
off the temperature inside when the appliance exceeds the normal running temperature. The heating
element will automatically stop working, the motor will continue to operate, the internal heat shed.
This protective device applies only to the appliance itself and has no influence on room temperature
regulation. In this case, unplug the appliance, wait about 10 minutes for it to cool and remove the
object that is obstructing the grids. Then switch it back on as described above. The appliance should
operate normally. Should the problem persist, please contact the nearest customer service.
· The unit is equipped with an anti-frost protection. Set the power to 1 and the temperature knob to
MIN, this ensures that the room does not freeze.
USE
1. Set the temperature knob to MIN and the position switch to 0. Plug in the appliance.
2. Set the position switch to 1 (1000 W) or 2 (1500 W). The power indication light indicates that the
appliance is operating.
3. Turn the temperature knob into the desired position. The button goes from MIN (16°C) to MAX
(32°C).
· The temperature indication light indicates that the appliance is heating up.
· If the indication light flashes, turn off the appliance. This means the appliance is overheated.
· Make sure the appliance is not covered and that there is enough space around the appliance for a
good ventilation.
· The indication light will go out when the set temperature is reached. When the temperature
drops 3°C under the set temperature, the thermostat will start operating again and the
temperature indication light will light up again.

CLEANING AND MAINTENANCE

· Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down
completely.
· To avoid the risk of electric shock, do not clean the heater with water and do not immerse it. Clean the
housing with a damp cloth.
· If necessary, dust particles accumulated in the air outlet openings may be removed with a vacuum
cleaner. This maintenance should be done regularly to assure the good operation of the appliance.
Dust particles in the appliance may cause over-heating.
· Store the appliance in a clean and dry place.
www.domo-elektro.be
29
DO7346M