Mettler Toledo IND560 PDX Guide D'installation page 59

Relay Outputs
The relay outputs can switch up to 250 VAC or 30 VDC voltages at 1A maximum.
The relay outputs are not polarity-sensitive since they are dry contact outputs. An
example of wiring to the outputs is given in Figure 2-46.
Allen-Bradley RIO
Connections to the A-B RIO option board (Figure 2-47) are made using a three-pin
terminal connector on the RIO option.
Figure 2-47: A-B RIO Option Board
IND560 PDX Installation Manual
NOTES:
1. DRY CONTACT RELAYS.
2. RELAY CONTACT RATING:
AC: 24-280 VAC, 1.0 AMP. INTO RESISTIVE
LOAD
DC: 5-24 VDC, 1.0 AMP. INTO RESISTIVE LOAD.
MAXIMUM SWITCHING POWER: 250VA, 30 W.
3. MAXIMUM OUTPUT CIRCUIT CURRENT = 3
AMPS.
4. ALL INDUCTIVE LOADS MUST BE SUPPRESSED.
5. WIRE SIZE: 14 AWG (2.088 mm
Figure 2-46: Relay Outputs
2
) MAXIMUM
2
22 AWG (0.322 mm ) MINIMUM.
2-29