Charger Wall Mount - Festool CXS Guide D'utilisation

3-1
3
Charging the battery pack Fig. [5]
The battery pack is delivered partially charged.
Charge the battery pack completely before us-
ing for the first time.
To charge the battery pack, put it on the retainer
[4-1] on the charger.
To remove, pull off the charged battery pack.
4
10
The charger MXC can be used to charge all Festool
battery packs of the BP-XS series.
The LED [4-2] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack will be charged with max. current.
LED green - flashing slowly
Battery Pack is charged to 80 % and will be charged
with further reduced current.
LED green - lit continuously
Battery pack is fully charged.
LED red - lit continuously
Battery temperature is outside the permitted
range.
LED red - flashing
General fault display, e. g. incomplete contact,
short circuit, battery pack faulty, etc.
The charger MXC has two elongated holes on its
back. It can be mounted on a wall using two screws
(e.g. round head or flat head screw with shank di-
ameter of 5 mm) (see Fig. Fig. [5]).
5
3 mm
4-1
4-2

Charger wall mount

85 mm
(3 11 32 '')