SOLIS 791 Mode D'emploi page 29

APPLIA NCE DE S CRIP T IO N
▲
A Grill plate with two usable sides:
• Classic grill plate with grooved and smooth zone; the grooved area is suitable
for grilling meat, the smooth area for grilling fish, seafood, vegetables etc.
• Grill plate with round insets for preparing crêpes, or as a heater plate for the
8 round mini-woks.
The grill plate is made from die-cast aluminum, is extremely heat resistant and also
equipped with a special non-stick coating.
B Upper heating element (heating coil)
The heating coil is positioned directly beneath the grill plate, it heats the grill plate
and supplies the foods in the pans on the stainless steel plating directly beneath it
with top heat.
The temperature of the heating coil is smoothly adjustable thanks to the temper-
ature control.
C Stainless steel plating
The raclette pans and round mini-woks are placed on the stainless steel plating
during grilling to gratinate and heat their contents.
D Lower heating element
Another heating element is placed underneath the stainless steel plating. It
can be switched on in addition to the upper heating coil with an extra button.
Like that, the foods on the stainless steel plating can be heated from below as well.
This is ideal f.e. for small pizzas, gratins or for warming up foods.
CAUTION: The lower heating element can not be switched on individually, only in
addition to the upper heating coil. The temperature of the lower heating element
can not be adjusted.
E Stainless steel feet with plastic knobs
Thanks to the plastic knobs there will not be any scratches on the plate below.
F Stainless steel plate (cold zone)
The stainless steel plate, the so-called cold zone, serves as a tray for unused pans
and spatulas during grilling.
It is separated from the grill itself and thus can be easily removed and cleaned.
There are additional plastic knobs on the corners of the tray to prevent it from
scratching the table.
56
G Red main switch, activates the upper heating element
The red main switch is for switching the appliance on and off. Once the red main
switch is set to „I" and the red light is glowing, the heating coil begins to heat up.
The desired temperature can be set with the temperature control.
H Temperature control
You can smoothly adjust the temperature of the upper heating element with the
temperature control. The bigger the dots around the temperature control, the hot-
ter the upper heating element gets.
Once the appliance has been switched on with the red main switch, a red or green
light glows around the temperature control.
Turn the temperature control to the right (clock wisely) to the desired position.
The light surrounding the temperature control glows red as long as the appliance
heats up.
Once the set temperature is reached, the light surrounding the temperature control
switches to green.
This will happen within the first approx. 75% of the heating power range. Within
the remaining approx. 25% to the maximum heating power, the light surrounding
always lights up red.
Red light = Heating-up phase
Green light = Temperature has been reached
CAUTION: The power cord has to be removed from the appliance resp. the power
plug has to be pulled if you do not use the appliance.
I Lower heating element switch with control light
You can additionally activate the lower heating element with the black switch.
Once you have set the switch to „I", the adjacent control light lights up. Then, also
the heating element underneath the stainless steel plating heats up, heating the
pans from below as well. The temperature for the lower heating element can not
be adjusted.
CAUTION: The lower heating element can only be activated in addition to the
upper heating element, it can not be activated individually.
J Appliance jack for connection adapter of power cord
The connection adapter on the power cord has to be connected to this appliance
jack before the power cord is plugged into the power socket to connect the appli-
ance to the power grid.
57