Kasanova E-MOTIKA Manuel D'instruction page 67

INSTRUCTION MANUAL
67
2. The battery can be directly put on the bike for charging but can also be taken down
from the bike to be charged indoors and in other appropriate places.
3. Connect first properly the output plug of the charger with the charging jack of the bat-
tery, and then connect the input plug of the charger to the AC power supply.
4. At this time, the power indicator light and the charge indicator light of the charger are
on, indicating that the charging has been connected.
5. After charging, should first pull out the AC power plug, and then pull out the plug con-
nected with the battery.
After the battery is fully discharged, the one-time charging time is 6 to 8 hours, and after
the charge indicator light turns from red to green, the power capacity of the battery is suf-
ficient.
A new bike needs a charging time of 4 to 6 hours after depth discharging for the first time,
and the one-week depth charging and discharging is a cycle to fully activate the active
substances inside the battery. Later, it can be re-charged even if its power is not used up.
Battery reaches its optimal performance after 3 fully charged-fully discharged cycles.
WARNING - Common sense of charging and use:
* The battery should be charged in a spacious environment, staying away from high
temperatures, high humidity and open fire, because battery and charger are electric
products; high temperatures and humidity will corrode electronic components, result-
ing in some harmful gases and soot, and even a possible explosion to wound.
* The charging time should not be too long. A long charging will lead to shortened life
expectancy of the battery.
* After the battery is fully charged, the power supply should be pulled out as soon as
possible, and at the same time, the battery is taken out of the charger.
* When the battery is not used for a long term, the battery power should be emptied
before the battery is preserved, and it is re-charged once every month or so.
3.4 Quick release system of the seat
1. Move the quick release handle to OPEN position (OPEN sign faces
to the operator).
2. Rotate clockwise the adjusting nut, only until it contacts with the seat connector, and
then turn a circle or semi-circle in the opposite direction and push the quick release han-
dle to CLOSE position (as shown).
3. Push the side and front part of the seat by force; if the seat rotates upward at the left
and right or downward from up to down, should first check whether the seat bunch is
locked, and then check whether the quick release device is locked, and repeat the opera-
tions above if necessary.