Charging Your Yeti; Charging From Solar; Charging From The Wall - GOAL ZERO Power from Yeti 150 Mode D'emploi

Charging Your YETI

CHARGE ME NOW: Before using or storing, plug your YETI into the wall until it is fully
charged. If at any point you hear a beeping from your YETI, plug it into a power source,
like an AC outlet or a solar panel, as soon as possible. This built-in warning indicator is
to help prevent battery damage when the charge gets low. For more tips and tricks on
keeping your battery healthy, see the BATTERY 101 section.
LCD Battery Display: The LCD Battery Display indicates the charge level of your YETI.
There are 5 segments to the battery, approximating 20% - 40% - 60% - 80% -100%
capacity. As you use your YETI, segments will disappear from the display, indicating the
remaining charge. When charging your YETI you will notice a battery segment blinking
at a 1 second interval. This indicates the current charge status. Once your YETI is fully
charged, all battery segments will be lit and remain solid.
NOMAD 20
Solar Panel

Charging from Solar

1. Place your solar panel where it will get as much direct sunlight as
possible. See the graphic in the SOLAR 101 section for help.
2. Insert the blue-ringed plug into the INPUT port on the front of the YETI.
You will know the YETI is charging when the blue LED light next to the
INPUT port lights up, and the battery segments in the LCD BATTERY
DISPLAY are blinking. The YETI is fully charged when all battery segments
stop blinking and remain solid.
3. Your YETI is capable of taking in up to 60W of solar power. Some GOAL
ZERO panels are chainable to provide more power to your YETI and reduce
solar charge times.
When connecting older versions of the NOMAD and BOULDER Solar Panels, use the
Legacy-Nomad Adapter Cable to connect to the YETI.
4
GOAL ZERO YETI 150 LAPTOP
Portable Power Station
17 Hours 2 Recharges
Full Sun
GOAL ZERO YETI 150
Portable Power Station
6 Hours

Charging from the Wall

Using the included AC Wall Charger, plug your YETI into any wall outlet. You will know
the Yeti is charging when the blue LED light next to the INPUT port turns on, and battery
segments in the BATTERY DISPLAY are blinking. The YETI is fully charged when all
battery segments stop blinking and remain solid. The YETI should recharge from the wall
in about 6 hours.
Charging from your Car
Although not recommended because of slow charge times, you can charge your
YETI from any 12V source, like your car. To charge your YETI from a car or 12V
source, you will need to purchase an 8.0 mm to 12V charger from GOALZERO.
com. Call our Customer Solutions Center at 1-888-794-6250 for help
identifying the charger.
LAPTOP
2 Recharges
1. The AC wall charger comes in two
pieces. Connect the two pieces by
plugging the cable into the box
5