Agilent Technologies TPS-mobile 9698400 Notice De Mode D'emploi page 386

17 Technical Information
Letter Protocol Description
216 R N
224 R A
226 R N
300 R N
301 R N
302 R N
320 Reserved to Agilent service
to 399
400 R A
402 R A
404 R A
500 Reserved to Agilent service
503 R/W N
504 R/W L
1.
NOTE
2.
386/400
Controller Air Temperature ( °C).
Pressure reading Format = X.X E XX
Rotation Frequency (rpm)
Cycle time in minutes (zeroed by the reset
command)
Cycle number (zeroed by the reset
command)
Pump life in hours (zeroed by the reset
command)
CRC EPROM (QE)
CRC Param. (PA)
CRC Parameter structure
RS 485 address
Serial type select
Automatic means that when the controller stops, the vent valve is
opened with a delay defined by window n. 126; when the
controller starts, the vent valve is immediately closed.
On command means that the vent valve is opened or closed by
means of window n. 122.
7
TOO HIGH LOAD
SHORT CIRCUIT
OVERVOLTAGE
AUX FAIL
6 5 4 3 2
TPS-mobile User Manual / 87-901-005-01 (F)
0 to 999999
0 to 9999
0 to 999999
QE8XXXX (where "XXXX"
are variable)
PA8XXXX (where "XXXX"
are variable)
"XXXX"
0 to 31 (default = 0)
0 = RS 232
1 = RS 485 (default = 0)
1 0
NO CONNECTION
PUMP OVERTEMP.
CONTROLL. OVERTEMP.
POWER FAIL