Vetus WW Série Instructions D'installation Et Mode D'emploi Destiné Au Propriétaire page 8

• Make sure the tank is properly fitted to a sturdy wall.
• The size of the tank increases slightly when it is full Take this
into account when fixing the tank in place.
• Attach the tank using the stainless steel rings supplied.
• If possible, provide support for the tank. The tank can be support-
ed within the hatched area.
• A profile may be used to provide support.
2 2 Tank fittings
The following parts are already pre-assembled on the top of the tank.
- Fitting 38 mm (1 1/2") with suction pipe (extraction) (1)
- Fitting 19 mm (3/4") breather (ventilation) (2)
- Inspection lid (3)
A 38 mm fitting for the drain connection is fitted in place at the bot-
tom of the tank.
One ø 43 mm hole (4) for the supply has been drilled in the top.
If more supply connections are required drill extra holes (ø 43 mm)
for the extra fittings.
• Select the place for the fittings so that if the ship is sailing heeled
over contaminated water from the waste water tank cannot flow
back to the toilet or flow out of the tank through the tank vent
pipe.
• If necessary loosen the nut with the spanner supplied in order to
turn the fittings to the required direction. Remember to tighten
up the nut properly afterwards.
• Remove any dust from drilling or cutting from the tank.
8
110116.04
2
1
The fitting (or fittings) for the supply must be ordered sepa-
rately to fit the particular hose connection size required
(19 mm (3/4"), 25 mm (1") or 38 mm (1 1/2") resp )
Rigid waste water tanks for black water, bulkhead mounted
4-12445
4
3