Publicité
- en -
Dear customer
Thank you very much for choosing a weka product.
Read these instructions through completely before assembling your product in order to avoid errors
In assembly or damage.
IMPORTANT
Please use the enclosed packing list to check immediately that your weka product has been
Delivered complete and intact.
Please do not dispose of the packing list before the guarantee period has expired. This list enables you to check
that all the individual parts are present. It should be retained along with the proof of purchase. Any complaints
which may arise can probably be easily rectified with this list. The item numbers on the packing list do not
correspond to the item numbers in the following assembly instructions.
We recommend that 2 people carry out the assembly.
In order to prevent accidents, we recommend that children are kept out of the direct vicinity during
assembly. We reserve the right to make further technological developments.
This means that there many be minor Deviations in the illustrations.
Please do not simply throw away the packaging material. Paper, card and corrugated board as well
as plastic packaging materials should be placed in the correct collection containers.
Wood
Healthy knots, light discoloration and small cracks are characteristic of the wood, lending the cabin its natural
appearance. They are therefore not grounds for complaint.
Prior to assembly
A minimum room height of 220 cm is required to set up the cabin.
The wall clearance should be at least 10cm.
The floor must be level and horizontal, as otherwise it may cause functional interference.
The best location for your cabin would be a dry, well ventilated room. A stone or tiled floor is both a practical and an
attractive floor covering. If there is a different floor covering, a slab with minimum dimensions of 40 x 50 cm must
be placed below the stove to prevent damage to the floor.
Safety tips
Do not place any objects on the sauna furnace – THERE IS A FIRE RISK!
Before the heating phase begins, ensure that no flammable objects are located in the vicinity of the furnace.
Only use the sauna infusion concentrate in diluted form. Information on correct usage can be found on the
containers.
Do not use any chemical adhesives inside the sauna. Only wood glue may be used.
After using the sauna, leave the door open to allow it to cool down.
Ensure that the room in which the sauna is located is well ventilated.
The information plate is to fixed in a clearly
visible position near the sauna furnace.
Care instructions
In order to ensure that you are able to benefit from the sauna for a long time to come, clean it regularly.
The unsurpassed mild and beneficial climate in the sauna is achieved as a result of the natural diffusion and
storage ability of the solid wood.
For this reason, the surface of the wooden sections must not be treated in any way.
If the sauna is not used for some time, we recommend that it is heated up for at least half an hour, once a week.
This will prevent any unwanted buildup of moisture.
A small amount of resin discharge from the wood surface is unavoidable. The dry resin residue can be removed
with fine sandpaper.
Copyright weka-Holzbau GmbH, Neubrandenburg
Technische. Änderungen vorbehalten!
4
Publicité
