Cleaning And Care; Replacing The Light Bulbs - Viva VVA62E150 Notice D'utilisation Et De Montage

Filters and maintenance
Inserting the filter:
1. Remove the metal filters (see "Removing
and inserting the metal grease filters").
2. Insert an activated carbon filter on the
right and left of the fan motor and rotate
the filters until they lock into position.
1.
2.
3. Insert the grease filters (see removal and
installation of the metal-mesh grease
filters).
Removing the filter:
The filters are removed in reverse
sequence.
Replacing the activated carbon filters:
K During normal operation (1 to 2 hours
per day) the activated carbon filters
should be replaced approximately 1 x
year.
K The activated carbon filters are available
from specialist outlets (see Optional
accessories).
K Use only original filters.
The appliance is then guaranteed to
function perfectly.
Disposal of old activated carbon filters:
K Activated carbon filters do NOT contain
any harmful substances. They can
therefore be disposed of as household
refuse.
12

Cleaning and care

Isolate the extractor hood by pulling out
the mains plug or switching off the fuse.
Do not clean the extractor hood with
abrasive sponges or with cleaning agents
which contain sand, soda, acid or chlorine!
K Clean the extractor hood with a hot soap
solution or a mild window cleaner.
K Do not scrape off dried-on dirt but wipe
off with a damp cloth.
K When cleaning the grease filters, remove
grease deposits from accessible parts of
the housing. This prevents the risk of fire
and ensures that the extractor hood
continues operating at maximum
efficiency.
Clean the switch with a soft, damp
cloth (mild detergent solution) only.
Do not use stainless steel polish on the
switch.
Stainless steel surfaces:
K Use a mild non-abrasive stainless steel
cleaner.
K Clean the surface in the same direction
as it has been ground and polished.
K We recommend our stainless steel
cleaner no. 461731.
See enclosed service booklet for order
address.
Aluminium, coated and plastic surfaces:
K Do not use dry cloths.
K Use a mild window cleaning agent.
K Do not use aggressive, acidic or caustic
cleaners.
Observe the warranty regulations in the
enclosed service booklet.

Replacing the light bulbs

1. Switch off the extractor hood and pull
out the mains plug or switch off the
electricity supply at the fuse box.
2. Remove the grease filters (see Filters and
Maintenance).
3. Press down the bulb cover and
disconnect from the light strip.
4. Replace the bulb (standard filament bulb,
max 40 W, E14 bulb holder).
5. Attach the lamp cover again.
6. Re-insert the grease filters.
7. Plug the appliance into the mains or
switch it on at the fuse box.