Using The Seat Heater - Dometic MAGICCOMFORT MSH300 Instructions De Montage Et De Service

Masquer les pouces Voir aussi pour MAGICCOMFORT MSH300:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31

Using the seat heater

Electrical connection
MSH300
The complete circuit diagram can be found in fig. h, page 6.
MSH301
The complete circuit diagram can be found in fig. i, page 7.
A
NOTICE!
Ensure it has been securely fitted, particularly in the area of the seat rails.
➤ Attach the switchbox to a suitable location in the vicinity of the dashboard
(fig. j, page 8).
➤ Find a suitable place for installing the seat heater switch.
If possible, use the blanking plugs provided for this purpose.
Ensure that there is enough room behind the panel for the installation of the
switch.
➤ Mark the switch cut-out using the template provided (fig. k, page 8).
➤ Cut out the marked area with an appropriate tool.
➤ Install the switch into the cut-out (fig. f, page 5).
➤ Install the ready-made wiring harness so that the cables cannot bend or fray
(fig. g, page 5).
7
Using the seat heater
I
NOTE
The seat heating logo (fig. l 1, page 8) also lights up when the seat
heating is switched on.
➤ Press the seat heater switch to turn on the seat heater:
– Press once: Level 3 (high heat output)
– Press twice: Level 2 (medium heat output)
– Press three times: Level 1 (low heat output)
✓ One, two or three LEDs (fig. l 2, page 8) on the switch light up in red.
➤ To switch the seat heating off: Press the switch until the LEDs (fig. l 2, page 8)
on the switch go out.
18
MSH300, MSH301
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Magiccomfort msh301

Table des Matières