Technical Specifications; Electrical Wiring - Buffalo DN487 Mode D'emploi

UK
Troubleshooting
Fault
The unit is not The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Coffee is not No water in reservoir
coming from the
Coffee is too compact within the
filter basket
filter
Loud noise coming No water in reservoir
from appliance

Technical Specifications

Model Voltage
220-240V
DN487
50/60Hz

Electrical Wiring

This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
4
Probable Cause
Power Current
9.1A
1739-2069W
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
Turn Off and fill reservoir
Turn off, loosen coffee within the filter and
resume
Turn Off and fill reservoir
Reservoir
Weight
Capacity
2.2 litres 5.8kg
Action
Dimensions
h x w x d mm
455 x 205 x 405